Additional information
| Weight | 1 lbs |
|---|---|
| Dimensions | 8 × 4 × 1 in |
Sale!
Musikraft Guitar Neck Measuring Tools (Free Domestic Shipping Only)
Original price was: $59.00.$49.00Current price is: $49.00.
-
Nut Width:
To measure the nut width, ensure your calipers are zeroed out. Clamp the neck at the nut (side to side) as shown in the reference picture. Keep in mind that minor variations are normal, but if your measurement is close to a standard size, it will likely be considered that particular width. -
Heel Width:
This measurement is similar to the nut width. You’ll need to measure the neck at the widest part of the heel. For the most accurate measurement, remove the neck from the body. If removal isn’t possible, you can still get a fairly accurate measurement at the end of the neck near the fingerboard. -
Scale Length:
Measure from the neck side of the nut (or nut slot) to the middle of the crown on the 12th fret. Double this number to determine the scale length. For example, if you measure 12 ¾” to the 12th fret, the scale length would be 25 ½”, which is the standard Fender scale. -
Fingerboard Radius:
Use a radius gauge to determine the curvature of the fingerboard. The lower the number (e.g., 7 ¼”), the greater the arc, while higher numbers (e.g., 16″) indicate a flatter board. Place the gauge on the fretboard at both the 1st fret and the end of the neck to find the correct radius. The gauge slots allow for easy measurement without removing the strings. -
Heel Height:
The heel height is typically 1″ for most Fender-type necks but may vary slightly depending on the manufacturer. Our neck pockets are designed to accommodate necks with a 1″ heel height and a pocket depth of around 0.70″. To measure, pinch the heel from the bottom to the top of the fretboard’s crown. Remember, this measurement must be taken with the neck removed. -
Thickness at 1st Fret:
To measure thickness at the 1st fret, use calipers to pinch the neck in front of the fret. For a quick measurement without removing the strings, use our compensator block (0.20″ thick). Zero the calibers, clamp it over the thickness of the block and then zero it again. Now, set the block over the first fret. If the strings are removed, a standard front-to-back measurement at the 1st and 12th frets without the block will work. This will help identify the best neck profile for comparison with our back profile diagrams. -
Thickness at 12th Fret:
This is measured the same way as at the 1st fret, but at the 12th fret. -
Fret Height:
Extend the caliper’s tail and place it on the fretboard, pushing it down to the top of the fret. This will give you the fret height in decimal form. Precision is key here, but even with basic calipers, this method will provide a close estimate for determining the appropriate fret size. -
Fret Width:
Simply clamp the calipers on the fret (side to side) to measure the wire’s width.
